Problem getting Univers to run on new system

[Paul(Dragon)0043]

Hi all,

Having a slight problem getting Univers to work on my new system, I follow the Rafair Install guide 0.0.2.2. till the point where you close Univers and open up TS.

Whem I try to open up TS, i get an "MSCVCR100.dll is missing from your computer" message, then TS opens up, I go to plugins, and in the left window in red
it says "UR_Plugin TS.dll", and in red in the description window it says "plugin failed to load", failed to open plugin".

Anyone got any ideas how to fix this please, it is a shame as on the new system DCS 2.0 runs without a flicker.

Paul

[Paul(Dragon)0043]

Hi guy's,

Its ok, I fixed it, the Univers plugin is functioning correctly now.

Paul

[Teddy]

Good news, well done.

[Danny]

Hi Paul,

If you could, would you post how you solved it?

It may help others out with similar issues.

[Paul(Dragon)0043]

Hi Danny, I'll do my best, understand that you may have to replace a system file and could render your computer non functional, so Please backup the file you are going to replace, just in case something goes wrong.

Please note that without Univers installed, TS works flawlessly. It only played up after I installed Univers.

So after I installed Univers, when I tried to start TS I got the Error message "MSVCR100.dll is missing" after clicking ok, TS fired up after that, but when you try to start the Univers Plugin, it states that the plugin as failed and cannot be activated.

I uninstalled Univers before carrying out this procedure.

So I went on the internet and downloaded the "MSVCR100.dll" file into my downloads folder. Now Backup this file which is located in C:/Windows/System32 before you proceed.(If it is there at all).

Once you have your backup, replace it with the one you downloaded.

Thats it, I reinstalled Univers, went into TS and activated the Univers Plug-in

Hope this helps (and it is not to long winded).

Paul

[Danny]

Perfect, cheers m8